Need help? Use our Equipment Finder to choose the proper product for your application.

4 Qt Inset Pump - Solution Style

Model:PS-61/2P/N:82090List:$101.00 USD
  • Vegetable Inset Pump 4 Quart (3.8 L)

Fast Facts

This polycarbonate Solution™ pump dispenses thin to thick condiments and thicker sauces from a 4 qt vegetable inset in a non-heated food table. A full portion is 1 oz and can be reduced in 1/4 oz increments. Inset is sold separately.

Ideal For

  • Ambient or chilled food tables
  • Standardizing portions of dipping sauces like barbeque, honey mustard, ranch and tartar sauce
  • A wide range of products from Cocktail Sauce to Sweet and Sour
Dispenses
Certifications:
NSF
Serving Application:
Ambient
Cold
  • 2-Year Warranty
  • Crafted In the USA

Key Benefits

  • Solution™ pumps dispense a variety of thick, thin and even thicker products with particulates by selecting (1) of the (3) discharge fittings included
  • Portion-controlled serving; 1 oz portion is adjustable in 1/4 oz increments
  • NSF listed for complete disassembly and easy cleaning
  • The polished stainless steel lid sets over the rim of your 4 quart vegetable inset (inset sold separately)
  • 2-year warranty
  • Specifications
  • Documentation
  • Videos
  • Trouble Shooting
Height Above Container7 1/8"
Lid Diameter7 9/16"
Weight2 lb
Cutout6 1/2"
Works With4 qt vegetable inset
Capacity4 qt
Dispense Typepump
Full Portion1 oz
Portionadjustable in 1/4 oz increments; up to 1 oz
NSF ListedY
BPA FreeY

Brochures

Specification Sheet

Manuals

Parts Breakdown

CAD Drawings

Problem:

Why is my Solution pump dripping product?

Solution:

Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If your product is dripping, it may need the next smaller opening from what is installed. Too hard to push? Use the discharge fitting with a larger opening.

Problem:

Why is my Solution  pump difficult to push down to pump?

Solution:

Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If it's too hard to push, you may need the discharge fitting with the next larger opening.

Problem:

Why does my Solution pump dispense only a little or no product?

Solution:

When this happens on a Solution pump, the first place to look is within the pump assembly. With the pump apart, check if the ball valves and seal are properly installed. Ball valves must be facing downward.

Our trick to remembering this is to say, in your mom's voice, "Put the BALL DOWN!". My bet is you won't forget it, no matter how hard you try.

Problem:

Why isn't my Solution pump returning to the start position after dispensing?

Solution:

If the plunger is not returning to start position after dispensing, it may likely be a broken spring. The spring is a replacement piece that will eventually wear out and break.

Sometimes how the pump is assembled can cause it to "lock-up" somewhat. During assembly, compress the pump and spring, while aligning flats on piston with the flats inside the cylinder. Another tip is the locking collar should be installed with the pump compressed.

Recent and Recommendations

* Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost. The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.

top