Skip to Content
Server Products Commerical Food Service Equipment
Main Content

1/4-Size Pan Pump - Solution Style

Model:PS-1/4P/N:83210GTIN:687329014187List:$138.32 USD
Wish List How To Buy
  • 1/4-Size Pan Pump - Solution Style
Fast Facts

This polycarbonate Solution™ pump dispenses thin to thick condiments and thicker sauces from a 1/4-size pan in a non-heated food table. A full portion is 1 oz and can be reduced in 1/4 oz increments. Pan is sold separately.

Ideal For
  • Ambient or chilled food tables
  • Standardizing portions of sandwich toppings like barbeque, honey mustard or tartar sauce
  • Serving ranch, French or southwest dressings at a house salad station
  • A wide range of products from thin syrups to pumpable relish
Dispenses:
Thin
Thick
Thicker
Certifications:
2YrWarranty
NSF
Warning-Prop65
Serving Application:
Ambient
Cold
Key Benefits
  • Solution™ pumps dispense a variety of thick, thin and even thicker products with particulates by selecting (1) of the (3) discharge fittings included
  • Portion-controlled serving; 1 oz portion is adjustable in 1/4 oz increments
  • NSF listed for complete disassembly and easy cleaning
  • Polished lid sets over a 1/4-size food pan, 6" deep (pan sold separately)
  • Documentation
  • Trouble Shooting

Specification Sheet

Problem:

Why is my Solution pump dripping product?

Solution:

Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If your product is dripping, it may need the next smaller opening from what is installed. Too hard to push? Use the discharge fitting with a larger opening.

Problem:

Why is my Solution  pump difficult to push down to pump?

Solution:

Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If it's too hard to push, you may need the discharge fitting with the next larger opening.

Problem:

Why does my Solution pump dispense only a little or no product?

Solution:

When this happens on a Solution pump, the first place to look is within the pump assembly. With the pump apart, check if the ball valves and seal are properly installed. Ball valves must be facing downward.

Our trick to remembering this is to say, in your mom's voice, "Put the BALL DOWN!". My bet is you won't forget it, no matter how hard you try.

Problem:

Why isn't my Solution pump returning to the start position after dispensing?

Solution:

If the plunger is not returning to start position after dispensing, it may likely be a broken spring. The spring is a replacement piece that will eventually wear out and break.

Sometimes how the pump is assembled can cause it to "lock-up" somewhat. During assembly, compress the pump and spring, while aligning flats on piston with the flats inside the cylinder. Another tip is the locking collar should be installed with the pump compressed.

* Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost.
The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.