Server Products makes every effort to publish accurate information on the website. "Google Translate" is provided as a free tool for visitors to read content in one's native language. Translations are not guaranteed to be 100% accurate. Neither Server Products nor its employees assume liability for erroneous translations of website content.
Return to Listing
Dispense directly from a manufacturers gallon (3.8 L) jar with a Polycarbonate, Solution style pump. Models are available for 89, 110 and 120 mm diameter jar openings (over threads).
Whether helping you conserve energy, reduce waste, cut costs, save time or lessen your environmental footprint, at Server we believe better really does matter.
Versatile Solution pumps dispense thin and thick foods from manufacturer's food containers; #10 can, gallon jar, jug, crock & more | See specs
3 qt (2.8 L) Stainless Steel Jar and storage lid for use in place of #10 manufacturer cans | 94009 Specs
Replacement parts information for Express & Solution Pump | Dome, Pinch Valve, Housing, Discharge Fittings, Express Tube and Connector
Update Bulletin | Proposition 65 Requirements – Warning Labels
How to assemble a Server Products Solution Pump.
How to disassemble a Server Products Solution Pump.
Why is my Solution pump dripping product?
Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If your product is dripping, it may need the next smaller opening from what is installed. Too hard to push? Use the discharge fitting with a larger opening.
Why is my Solution pump difficult to push down to pump?
Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If it's too hard to push, you may need the discharge fitting with the next larger opening.
Why does my Solution pump dispense only a little or no product?
When this happens on a Solution pump, the first place to look is within the pump assembly. With the pump apart, check if the ball valves and seal are properly installed. Ball valves must be facing downward.
Our trick to remembering this is to say, in your mom's voice, "Put the BALL DOWN!". My bet is you won't forget it, no matter how hard you try.
Why isn't my Solution pump returning to the start position after dispensing?
If the plunger is not returning to start position after dispensing, it may likely be a broken spring. The spring is a replacement piece that will eventually wear out and break.
Sometimes how the pump is assembled can cause it to "lock-up" somewhat. During assembly, compress the pump and spring, while aligning flats on piston with the flats inside the cylinder. Another tip is the locking collar should be installed with the pump compressed.
* Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost. The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.
3601 Pleasant Hill Rd
Richfield, WI 53076
© 2019 Server Products, All rights reserved