NEW Touchless Express Stations  | View Full Details

Server Products Commerical Food Service Equipment

2 Qt Fountain Jar Pump | Solution

Model:PS-200P/N:84060GTIN:687329015504List:$117.22 USD
  • 2 Qt Fountain Jar Pump | Solution
Fast Facts

The PS-200 polycarbonate Solution™ pump with stainless steel lid dispenses from your standard 2 quart (1.9 L) fountain jar. Unlike many plastic pumps, the Solution™ pump offers adjustable portion control, can be disassembled, and is dishwasher safe and NSF listed. Each press or stroke serves a 1 oz (30 mL) maximum portion or can be reduced in 1/4 oz (7 mL) increments.

Ideal For
  • Dispensing thin syrups, thick condiments or thicker craft sauces simply by selecting (1) of the (3) discharge fittings included
  • Managing food costs and serving a consistent food experience
  • BOH or self-serve, countertop condiment stations
Serving Application:
  • Specifications
  • Documentation
  • Videos
  • Trouble Shooting
Height Above Container9 1/8" | 23.2 cm
Width4 1/2" | 11.4 cm
Depth7 1/8" | 18.1 cm
Weight2 lb | .9 kg
Dimensional Weight3 lb | 1.4 kg
International Dim Wt4 lb | 1.8 kg
Cutout4 5/16" x 7" | 11 x 17.8 cm
Works With2 qt (1.9 L) fountain jar
Capacity2 qt | 1.9 L
Dispense Typepump
Full Portion1 oz | 30 mL
Portionadjustable in 1/4 oz (7 mL) incrments; up to 1 oz (30 mL)
NSF ListedY


Specification Sheet


Parts Breakdown

Resource Documents

CAD Drawings


Why is my Solution pump dripping product?


Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If your product is dripping, it may need the next smaller opening from what is installed. Too hard to push? Use the discharge fitting with a larger opening.


Why is my Solution  pump difficult to push down to pump?


Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If it's too hard to push, you may need the discharge fitting with the next larger opening.


Why does my Solution pump dispense only a little or no product?


When this happens on a Solution pump, the first place to look is within the pump assembly. With the pump apart, check if the ball valves and seal are properly installed. Ball valves must be facing downward.

Our trick to remembering this is to say, in your mom's voice, "Put the BALL DOWN!". My bet is you won't forget it, no matter how hard you try.


Why isn't my Solution pump returning to the start position after dispensing?


If the plunger is not returning to start position after dispensing, it may likely be a broken spring. The spring is a replacement piece that will eventually wear out and break.

Sometimes how the pump is assembled can cause it to "lock-up" somewhat. During assembly, compress the pump and spring, while aligning flats on piston with the flats inside the cylinder. Another tip is the locking collar should be installed with the pump compressed.

Recent and Recommendations

* Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost.
The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.