Skip to Content
Main Content

Solution Pump Stations

Model:Solution SR-2 | SR-3 | SR-4
  • Stations with Solution Pumps
Fast Facts

The Solution pump station is ideal for portion-controlled dispensing of seasonal menu items with varying consistencies. A stainless steeel base holds two, three or four condiments and sauces in 3 1/2 quart fountain jars for your countertop.

Ideal For
  • Condiments, syrups and sauces best served in ambient temperatures; from thick to thin
  • Improved flavor profile with consistent portions serving after serving
  • BOH salad bars and wait stations
Serving Application:

Polycarbonate Solution pumps are quite versatile in their ability to dispense a variety of thick, thin and even products with particulates. Unlike most plastic pumps, Solution pumps offer adjustable portion control, can be disassembled, are dishwasher safe and NSF listed. A 1 ounce serving is the maximum portion per stroke and can be reduced in 1/4 ounce increments.

Key Features

  • Brushed finish base reduces the visibility of fingerprints
  • Polycarbonate Solution pumps; parts are removable & dishwasher safe
  • 1 oz portion, adjusts in 1/4 oz increments
  • Dispenses thin syrups to pumpable relish with discharge fittings included
  • 3 1/2 quart, white plastic fountain jars


  • Variations
  • Documentation
  • Videos
  • Trouble Shooting
 DescriptionModelp/nCapacityServing ApplicationServing MethodList Price 
SR-3Serving Station | (3) Jars & Solution™ PumpsSR-379860(3) 3 1/2-quart
Pump$723.08 USD More Info Wish List
SR-4Serving Station | (4) Jars & Solution™ PumpsSR-479870(4) 3 1/2-quart
Pump$925.77 USD More Info Wish List

Specification Sheet


Why is my Solution pump dripping product?


Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If your product is dripping, it may need the next smaller opening from what is installed. Too hard to push? Use the discharge fitting with a larger opening.


Why is my Solution  pump difficult to push down to pump?


Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If it's too hard to push, you may need the discharge fitting with the next larger opening.


Why does my Solution pump dispense only a little or no product?


When this happens on a Solution pump, the first place to look is within the pump assembly. With the pump apart, check if the ball valves and seal are properly installed. Ball valves must be facing downward.

Our trick to remembering this is to say, in your mom's voice, "Put the BALL DOWN!". My bet is you won't forget it, no matter how hard you try.


Why isn't my Solution pump returning to the start position after dispensing?


If the plunger is not returning to start position after dispensing, it may likely be a broken spring. The spring is a replacement piece that will eventually wear out and break.

Sometimes how the pump is assembled can cause it to "lock-up" somewhat. During assembly, compress the pump and spring, while aligning flats on piston with the flats inside the cylinder. Another tip is the locking collar should be installed with the pump compressed.

* Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost.
The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.