Skip to Content
Server Products Commerical Food Service Equipment
Main Content

Serving Station | (4) Jars & Solution™ Pumps

Model:SR-4P/N:79870GTIN:687329007707List:$925.77 USD
Wish List How To Buy
  • Rail Combo (4) Solution Pumps

This non-insulated rail combo includes (4) Solution™ pumps and deep plastic fountain jars. The stainless steel base features a brushed finish that reduces the visibility of fingerprints.

Polycarbonate Solution™ pumps are quite versatile in their ability to dispense a variety of thick, thin and even products with particulates. Unlike most plastic pumps, Solution™ pumps offer adjustable portion control, can be disassembled, are dishwasher safe and NSF listed. A 1 ounce (30 mL) serving is the maximum portion per stroke. Portions can be reduced in ¼ ounce (7 mL) increments, using the supplied gauging collars.

Standard features include:
  • Brushed finish base reduces the visibility of fingerprints 
  • (4) Polycarbonate Solution™ pumps
  • Parts are removable & dishwasher safe
  • 1 oz (30 mL) maximum portion, adjusts in ¼ oz (7 mL) increments
  • Dispense a wide range of cold products from syrups to relish by selecting (1) of the (3) discharge fittings included
  • (4) Deep plastic fountain jars
Dispenses:
Thin
Thick
Thicker
Certifications:
2YrWarranty
NSF
Serving Application:
Ambient
  • Specifications
  • Documentation
  • Videos
  • Trouble Shooting
GTIN687329007707
Dimensional Weight49 lb | 22.2 kg
International Dim Wt59 lb | 26.8 kg

Specification Sheet

Manuals

Problem:

Why is my Solution pump dripping product?

Solution:

Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If your product is dripping, it may need the next smaller opening from what is installed. Too hard to push? Use the discharge fitting with a larger opening.

Problem:

Why is my Solution  pump difficult to push down to pump?

Solution:

Solution pumps come with (3) discharge fittings with varying opening sizes. Thick products work with the largest opening and thin the smallest. If it's too hard to push, you may need the discharge fitting with the next larger opening.

Problem:

Why does my Solution pump dispense only a little or no product?

Solution:

When this happens on a Solution pump, the first place to look is within the pump assembly. With the pump apart, check if the ball valves and seal are properly installed. Ball valves must be facing downward.

Our trick to remembering this is to say, in your mom's voice, "Put the BALL DOWN!". My bet is you won't forget it, no matter how hard you try.

Problem:

Why isn't my Solution pump returning to the start position after dispensing?

Solution:

If the plunger is not returning to start position after dispensing, it may likely be a broken spring. The spring is a replacement piece that will eventually wear out and break.

Sometimes how the pump is assembled can cause it to "lock-up" somewhat. During assembly, compress the pump and spring, while aligning flats on piston with the flats inside the cylinder. Another tip is the locking collar should be installed with the pump compressed.

Recommended Items

    * Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost.
    The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.