Return to Listing
When wider is not an option... this Tiered Serving Station needs just 5" of countertop space. The tiered stainless steel base comes complete with two stainless steel pumps (FP-V 82120) and 3 1/2 quart, plastic fountain jars (82557). The FP-V stainless steel pumps dispense precise portions of thin syrups or flavors. Each press or stroke serves a 1 1/4 oz (37 mL) maximum portion or can be reduced in 1/8 oz (3.7 mL) increments. Contents can be quickly identified by specifiying a colored and engraved pump knob upon order, at no additional charge; black is standard.
Designed to squeeze into a tight spot, tiered two topping rails include pans, jars, spoons and clear lids or pumps | See specs
Manual for Server Products Stainless Steel Pump | Models CP-200, CP-F, FP, FP-V, FP-200, FP-200 DI, FP-200V, FP-1.5, FP-DI, TP-V, TP-200V | Includes: Parts & Use
Parts breakdown diagram for SST FP-V Vertical Pump | Model FP-V p/n 82120
How to install gauging collars to a Server Product stainless steel pump
How to disassemble a Server Products stainless steel pump for cleaning and/or perform the NSF approved procedure for Clean In Place (CIP).
How to assemble a Server Products stainless steel pump.
Trouble shooting a Server Products Stainless Steel Pump when the plunger won't return.
Trouble shooting a Server Products Stainless Steel Pump when product is oozing out of the locking collar.
How do I stop this pump from dripping?
To take care of this mess maker, check the seals and o-rings. If they look worn with tiny cracks or are misshapen, it's a good time for replacement.
Why is product oozing out around or under the locking collar?
First make sure that the seal is firmly installed on the piston and stem assembly, with the flare side of the seal facing down. If the seal was installed properly, it likely needs replacing.
Why isn't my pump returning to the top after dispensing?
Known to insiders as a plunger problem, it's typically either a missing washer or a broken/missing spring.
The washer is necessary to compress the spring, so if it's missing, your plunger will not return. A well-used spring can become worn out or broken. The spring is also necessary for pump operation. Now you can call yourself an insider too.
Your pump Model and Part number are stamped on the lid. With that information, a parts breakdown will determine replacement part numbers.
* Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost. The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.
CONTACT US
3601 PLEASANT HILL RD RICHFIELD, WI 53076 T: 800.558.8722 P: 262.628.5600 SPSALES@SERVER-PRODUCTS.COM
© 2016-2021 Server Products, All rights reserved