Return to Listing
Complete replacement pump for Touchless Express Dispensers that serve from a 1.3-gallon food jar (not included). Parts fully disassemble and are dishwasher safe with discharge fittings for dispensing thin and thick pouched condiments and dressings.
Introducing Touchless Express Dispensers. A better way to serve your sauces and condiments in a world where safety is everything. NEW Stations are all-together smarter!
Specification Sheet | Touchless Express Dispensing Systems for pouched and direct-pour condiments and toppings
Tips and tricks to help you get started with your new Direct-Pour, Touchless Express Unit: 100259 & 100367.
Manual for Direct-Pour Express Pump | p/n 100239 | Assembly, Disassembly, Cleaning, Troubleshooting
Evolving times require evolved thinking. Server Products introduces Touchless Express Condiment Dispensers for touch-free environments.
Why is the dome popping off the pump housing?
To avoid this headache in the future, it's good to know this is typically a simple fix. A little process fine tuning and we can put this behind us.
Checking for proper dome installation is done by observing the edges where it meets the pump housing. If all the lines around the dome edges are within the pump housing, it was installed correctly. Many times operators think the dome is installed completely because it seems "snug", yet a few of the dome edge lines are still visible from the side.
Lastly, it's possible some residual product may be causing pressure build up and a good cleaning will solve the problem; disassemble fully, thoroughly clean and air dry before setup again.
Why does my Express pump dispense a little or no product?
When this happens, the first place to look is under the lid to see if the product pouch is empty. With the lid in hand, you're able to confirm if the roller is installed onto the lever. If those two things looks good, deeper investigation is necessary.
Gently remove the pump and attached pouch from the vessel. Check to make sure the pump dome is installed completely - that means all the lines around the dome edges are within the pump housing. If all your moving parts look good, it's time to check the connection of the pump to the pouch.
Is the pouch fully pierced? A good way to be sure is to push the pump connecter piece further into the pouch fitment. If you hear a snap or click, it's in place now and you should be back in business.
Why doesn't this lid fit properly? Is it bent or misshapen? What happened to it?
First check to see if the dome is installed properly (see Dome Pops Off). If it's not the dome, the culprit tends to be the condiment bag within; it typically occurs with a new/full bag. An air gap may be preventing it from siting fully within the base with adequate room for the roller to make a proper connection with the pump dome.
Here's what I've done... Taking care not to separate the pouch from the pump, smooth out or reseat how the pouch rests in the bottom of the vessel and try installing the lid again.
* Server Products equipment is sold through dealers or distributors. The list prices shown throughout the site are for estimating cost.
The final cost may be lower or higher based on your location, taking into account taxes, landing fees, etc.
3601 PLEASANT HILL RD
RICHFIELD, WI 53076
© 2016-2022 Server Products, All rights reserved